Corner Pinning Settings - Sony XVS-9000 User Manual

Field: Do interpolation in field units. This gives
natural movement, suitable for movies.
Frame: Do interpolation in frame units. This gives
higher image precision, suitable for still pictures.
5
When [Adaptive] is selected in step 4, set the
following parameter.
No. Parameter Adjustment
1 Mode Degree of change detection
6
In the <Interpolation Mode> group, set the number of
pixels to use in interpolation.
Multi: Use multi-point interpolation. This gives
higher picture quality.
Linear: Use two-point interpolation.
7
In the <Filter Mode> group, select the method used to
control picture reduction or expansion.
Mode1: Even when the picture is reduced, add
compensation so that it can be seen clearly
(standard).
Mode2: Suppress aliasing when expanding or
reducing the picture (soft).
Mode3: Do not suppress aliasing when expanding or
reducing the picture (sharp).

Corner Pinning Settings

Note
When the Brick function is enabled, Corner Pinning
cannot be used.
Setting the foreground corner pinning
positions
1
Open the DME >Non Linear/Corner Pin >Corner
Pinning menu (4142).
2
Press [Corner Pinning], turning it on.
3
Press [Corner Marker], turning it on.
A marker appears for each corner. The marker for the
selected corner is distinguished from the other
markers.
4
In the <Corner Select> group, select the target corner
to set.
Top Left: Top left corner
Top Right: Top right corner
Bottom Left: Bottom left corner
Bottom Right: Bottom right corner
All: All four corners
5
Set the position of the corner selected in step 4.
No. Parameter Adjustment
1 Pos X
2 Pos Y
To reset the corner positions
Press [Reset Corner].
Selecting the target area of the foreground
When the foreground is cropped, select the target range.
In the Corner Pinning menu (4142), press [Crop Link],
turning it on, to set the cropped image as the target range.
When [Crop Link] is disabled, the whole picture, including
the invisible cropped portions (gray portions in the
following diagram), become the target range.
Target range with Crop Link enabled
Target range with Crop Link disabled
271
Active marker
Other markers
Movement in X-axis direction
Movement in Y-axis direction
( indicates the target range)