Destination Port - H3C SR6600 Command Reference Manual

Syntax
destination ip ip-address
undo destination ip
Default
No destination IP address is configured for the operation.
Views
DLSw operation view, FTP operation view, DNS operation view, HTTP operation view, ICMP echo
operation view, SNMP operation view, TCP operation view, UDP echo operation view, UDP jitter
operation view, voice operation view
Default command level
2: System level
Parameters
ip-address: Specifies the destination IP address of the operation.
Examples
# Configure the destination IP address of the ICMP echo operation as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ip 10.1.1.1

destination port

Use destination port to configure the destination port number for the operation.
Use undo destination port to remove the destination port number.
Syntax
destination port port-number
undo destination port
Default
No destination port number is configured for the operation.
Views
TCP, UDP echo, UDP jitter, or voice operation view
Default command level
2: System level
Parameters
port-number: Specifies the destination port number of the operation, in the range of 1 to 65535.
Usage guidelines
Do not perform the UDP jitter operation or the voice operation to any well-known port from 1 to 1023.
Otherwise, the operation fails or the service on that port becomes unavailable.
17