Source Port - H3C SR6600 Command Reference Manual

Use undo source ip to remove the configured source address. The IP address of the interface that sends
a probe packet serves as the source IP address of the probe packet.
Syntax
source ip ip-address
undo source ip
Default
No source IP address is configured for probe packets.
Views
DLSw operation view, FTP operation view, HTTP operation view, ICMP echo operation view, SNMP
operation view, TCP operation view, UDP echo operation view, UDP jitter operation view, voice operation
view
Default command level
2: System level
Parameters
ip-address: Specifies the source IP address of the operation.
Usage guidelines
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
If you configure the source interface command but not the source ip command for the ICMP echo
operation, the IP address of source interface is used as the source IP address of the ICMP echo request
packet.
Examples
# Configure the source IP address of the ICMP echo packets as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
Related commands
source interface

source port

Use source port to configure the source port of probe packets.
Use undo source port to remove the configured port number.
Syntax
source port port-number
undo source port
Default
No source port number is configured.
58