Ntp-Service Multicast-Server - H3C SR6600 Command Reference Manual

Syntax
ntp-service multicast-client [ ip-address ]
undo ntp-service multicast-client [ ip-address ]
Default
The device does not operate in any NTP operation mode.
Views
Interface view
Default command level
3: Manage level
Parameters
ip-address: Specifies a multicast IP address in the range of 224.0.1.0 to 239.255.255.255. The default
is 224.0.1.1.
Examples
# Configure the device to operate in multicast client mode and receive NTP multicast messages on
GigabitEthernet 2/0/1, and set the multicast address to 224.0.1.1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ntp-service multicast-client 224.0.1.1

ntp-service multicast-server

Use ntp-service multicast-server to configure the device to operate in NTP multicast server mode and use
the current interface to send NTP multicast packets.
Use undo ntp-service multicast-server to remove the configuration.
Syntax
ntp-service multicast-server [ ip-address ] [ authentication-keyid keyid | ttl ttl-number | version number ]
*
undo ntp-service multicast-server [ ip-address ]
Default
The device does not operate in any NTP operation mode.
Views
Interface view
Default command level
3: Manage level
Parameters
ip-address: Specifies a multicast IP address in the range of 224.0.1.0 to 239.255.255.255. The default
is 224.0.1.1.
authentication-keyid keyid: Specifies the key ID to be used for sending multicast messages to multicast
clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
81