H3C SR6600 Command Reference Manual page 203

No destination address or destination UDP port number is configured in system view or aggregation
view.
Views
System view, NetStream aggregation view
Default command level
3: Manage level
Parameters
ip-address: Specifies the destination IP address for IPv6 NetStream data export. Only IPv4 addresses are
supported.
udp-port: Specifies the destination UDP port number for IPv6 NetStream data export, in the range of 0
to 65535.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN that the IPv6 NetStream data export
destination belongs to. The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters.
If the destination is on the public network, do not specify the option.
Usage guidelines
If an aggregation view is not enabled, you cannot use the display ipv6 netstream export command to
view information (including the destination address and destination UDP port number) of the
aggregation view.
If the ip-address argument is not specified in the undo ipv6 netstream export host command, all IP
addresses configured in the current view are removed.
You can configure the same destination address and destination UDP port number in different
aggregation views.
The destination address and destination UDP port number configured in aggregation view takes
precedence over those configured in system view. If no destination address or destination UDP port
number is configured in aggregate view, those configured in system view apply.
Up to four different destination addresses, including addresses in different VPNs, can be configured in
one aggregation view. If you have configured the destination addresses with the same IP addresses but
different UDP port numbers, the last configuration takes effect. If you configure different VPN names,
configure destination addresses with the same IP address and UDP port number.
IPv6 NetStream traditional data is exported to all destination addresses configured in system view, and
IPv6 NetStream aggregation data is exported to all destination addresses configured in the related
aggregation view. If you expect IPv6 NetStream aggregation data only, configure the destination
address in the aggregation view, and do not configure the destination address in system view. Otherwise,
the IPv6 NetStream traditional data is also exported, which will increase the bandwidth occupation.
Examples
# Configure the address for IPv6 NetStream data export as 1.1.1.1, UDP port 5000, and vpn1.
<Sysname> system-view
[Sysname] ipv6 netstream export host 1.1.1.1 5000
Related commands
ipv6 netstream aggregation
•
• ipv6 netstream export source
195