Next-Hop - H3C SR6600 Command Reference Manual

Views
FTP operation view
Default command level
2: System level
Parameters
active: Sets the data transmission mode to active for the FTP operation. In this mode, the FTP server
initiates a connection request.
passive: Sets the data transmission mode to passive for the FTP operation. In this mode, the FTP client
initiates a connection request.
Examples
# Set the data transmission mode to passive for the FTP operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type ftp
[Sysname-nqa-admin-test-ftp] mode passive

next-hop

Use next-hop to specify the next hop for the ICMP echo operation.
Use undo next-hop to remove the next hop IP address.
Syntax
next-hop ip-address
undo next-hop
Default
No next hop IP address is configured for the ICMP echo operation.
Views
ICMP echo operation view
Default command level
2: System level
Parameters
ip-address: Specifies the IP address of the next hop.
Usage guidelines
If multiple paths exist between the source and destination devices, you can specify the device directly
connected to the source device on one of the paths as the next hop for the ICMP echo operation.
Examples
# Configure the next hop IP address as 10.1.1.1 for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] next-hop 10.1.1.1
35