Sflow Collector - H3C SR6600 Command Reference Manual

Use undo sflow agent to remove the configured IP address.
Syntax
sflow agent { ip ip-address | ipv6 ipv6-address }
undo sflow agent { ip | ipv6 }
Default
No IP address is configured for the sFlow agent. The device periodically checks whether the sFlow agent
has an IP address. If the sFlow agent has no IP address configured, the device automatically selects an
IP address for the sFlow agent but does not save the IP address in the configuration file.
Views
System view
Default command level
2: System level
Parameters
ip ip-address: Specifies an IPv4 address for the sFlow agent.
ipv6 ipv6-address: Specifies an IPv6 address for the sFlow agent.
Usage guidelines
H3C recommends that you manually configure an IP address for the sFlow agent.
Only one IP address can be specified for the sFlow agent on the device.
Examples
# Specify IP address 10.10.10.1 for the sFlow agent.
<Sysname> system-view
[Sysname] sflow agent ip 10.10.10.1

sflow collector

Use sflow collector to configure parameters for an sFlow collector.
Use undo sflow collector to remove an sFlow collector.
Syntax
sflow collector collector-id { { ip ip-address | ipv6 ipv6-address } | datagram-size size | description text
| port port-number | time-out seconds } *
undo sflow collector collector-id
Default
The device provides a number of sFlow collectors. Use the display sflow command to display these sFlow
collectors.
Views
System view
Default command level
2: System level
243