Reaction Checked-Element { Owd-Ds | Owd-Sd - H3C SR6600 Command Reference Manual

[Sysname-nqa-admin-test-voice] reaction 1 checked-element mos threshold-value 200 100
action-type trap-only

reaction checked-element { owd-ds | owd-sd }

Use reaction checked-element { owd-ds | owd-sd } to configure a reaction entry for monitoring the
one-way delay. You cannot edit a reaction entry. To change the attributes in a reaction entry, use undo
reaction to delete the entry first and then configure a new one.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element { owd-ds | owd-sd } threshold-value upper-threshold
lower-threshold
undo reaction item-number
Default
No reaction entry for monitoring the one-way delay is configured.
Views
UDP jitter operation view, voice operation view
Default command level
2: System level
Parameters
item-number: Specifies a reaction entry ID in the range of 1 to 10.
owd-ds: Specifies the destination-to-source delay of each probe packet as the monitored element.
owd-sd: Specifies the source-to-destination delay of each probe packet as the monitored element.
threshold-value: Specifies threshold values in milliseconds.
upper-threshold: Specifies the upper threshold in the range of 0 to 3600000.
lower-threshold: Specifies the lower threshold in the range of 0 to 3600000. It must not be greater than
the upper threshold.
Usage guidelines
Only successful probe packets are monitored. Failed probe packets are not counted.
No actions can be configured for a reaction entry of monitoring one-way delays. The monitoring results
and statistics can be displayed with the display nqa reaction counters and display nqa statistics
commands.
Examples
# Create reaction entry 1 for monitoring the destination-to-source delay of every UDP jitter packet. Set the
upper threshold to 50 milliseconds and lower threshold to 5 milliseconds. Before the NQA operation
starts, the initial state of the reaction entry is invalid. The destination-to-source delay is calculated after
the response to the probe packet arrives. If the delay exceeds the upper threshold, the state of the
reaction entry is set to over-threshold. If it is below the lower threshold, the state is set to below-threshold.
Once the state of the reaction entry changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
48