Info-Center Syslog Channel - H3C SR6600 Command Reference Manual

Default command level
2: System level
Usage guidelines
If system information is output before you input information at a command line prompt, the system does
not display the command line prompt after the system information output.
If system information is output when you are inputting some interactive information (non Y/N
confirmation information), the system displays your input in a new line after the system information
output.
Examples
# Enable synchronous information output, and then issue the display current-configuration command to
view the current configuration of the device.
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
[Sysname] display current-
At this time, the system receives log information. It displays the log information first, and then displays
your previous input, which is display current- in this example.
%Apr 29 08:12:44:71 2007 Sysname
GigabitEthernet2/0/1: link status is UP
Enter configuration to complete the display current-configuration command, and press the Enter key to
execute the command.
# Enable synchronous information output, and then save the current configuration (enter interactive
information).
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:
At this time, the system receives the log information. It displays the log information first and then displays
[Y/N].
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Y/N]:
Enter Y or N to complete your input.

info-center syslog channel

Use info-center syslog channel to configure the Web output channel. The system uses this channel to
output information to the Web interface.
Use undo info-center syslog channel to restore the default.
Syntax
info-center syslog channel { channel-number | channel-name }
undo info-center syslog channel
IFNET/4/LINK UPDOWN:
224