Reaction Checked-Element Probe-Fail (For Trigger) - H3C SR6600 Command Reference Manual

Views
DHCP operation view, DLSw operation view, DNS operation view, FTP operation view, HTTP operation
view, ICMP echo operation view, SNMP operation view, TCP operation view, UDP echo operation view
Default command level
2: System level
Parameters
item-number: Specifies a reaction entry ID in the range of 1 to 10.
threshold-type: Specifies a threshold type.
accumulate accumulate-occurrences: Specifies the maximum number of probe failures. The value is in the
range of 1 to 15.
consecutive consecutive-occurrences: Specifies the maximum number of consecutive probe failures. The
value is in the range of 1 to 16.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of only displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS. This keyword is not supported for the DNS operation.
Examples
# Create reaction entry 1 for monitoring the probe failures in ICMP echo operation. Before the NQA
operation starts, the initial state of the reaction entry is invalid. If the total number of probe failures
exceeds 10 (included), the state of the entry is set to over-threshold. If it is below the lower threshold, the
state of the entry is set to below-threshold. Once the state of the reaction entry changes, a trap message
is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
accumulate 10 action-type trap-only
# Create reaction entry 2 for monitoring the probe failures in ICMP echo operation. Before the NQA
operation starts, the initial state of the reaction entry is invalid. If the number of consecutive probe failures
exceeds 10, the state of the entry is set to over-threshold. If it is below the lower threshold, the state of the
entry is set to below-threshold. Once the state of the reaction entry changes, a trap message is generated
and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 2 checked-element probe-fail threshold-type
consecutive 10 action-type trap-only

reaction checked-element probe-fail (for trigger)

Use reaction checked-element probe-fail to configure a reaction entry for monitoring the probe failures.
This command is applicable to trap messages only. You cannot edit a reaction entry. To change the
attributes in a reaction entry, use undo reaction to delete the entry first and then configure a new one.
Use undo reaction to remove the specified reaction entry.
52