Admin | Snmp - Comtech EF Data SLM-5650B Installation And Operation Manual

8.6.5.2.4

Admin | SNMP

The Admin user, via the 'Admin | SNMP' page (Figure 8-13), may change the parameters
associated with Simple Network Management Protocol, an application-layer protocol designed to
facilitate the exchange of management information between network devices. The modem SNMP
agent supports SNMPv1, SNMP v2c, and SNMP v3 (see Chapter 6.4 SNMP Interface for
complete details on SNMP and using this page).
SNMP
SNMP Read Community and SNMP Write Community cannot be changed; the default for Read
Community default is public; the Write Community default is private.
Click [Submit] to enable the SNMP configuration changes made to Trap Community, Trap,
System Contact, and System Location.
SNMP v3
This section is used to create user accounts under SNMPv3 protocol. SNMPv3 is available only
when the IP Interface Security Mode security level setting is set to "High".
Using the provided text boxes, create an Engine ID (the default is 0000000c000000007f000001),
User Name and Password as needed (the default for both is comtech) then, using the available
drop-down menu, select the Security Model algorithm as md5 or sha. Note that this setting must
match the setting in the SNMP client, or the modem will not allow communications.
Click [Submit] to enable the SNMP v3 configuration changes made in this section.
Network Processor (NP) Interface
Figure 8-13. Admin | SNMP Page
8–18
SLM-5650B Satellite Modem
Revision 2
MN-SLM-5650B