Comtech EF Data SLM-5650B Installation And Operation Manual page 116

Front Panel Operation
CONFIG: Remote  EthernetConfig  SNMP  Traps 
Address #1/#2
SNMP Traps IP Address #X:
000.000.000.000
Where X indicates IP Address #1 or IP Address #2:
Use the arrow keys to select the digit to edit, and then use the 
arrow keys to edit the value of that digit. Press [ENT] when done.
If both Trap IP Addresses are 000.000.000.000, it
means that Trap is disabled.
CONFIG: Remote  EthernetConfig  SNMP  Traps 
Community
SNMP Trap Community:
comtech
Use the  arrow keys to select the character to edit, and then use the
arrow keys to edit that character.
Only the first 20 characters on the bottom line are
available.
All printable ASCII characters are available with the exception of the
backslash '/' (ASCII code 92) and tilde '~' (ASCII code 126).
Once the string has been composed, press [ENT]. All trailing spaces are
removed from the Trap Community string upon entry.
CONFIG: Remote  EthernetConfig  SNMP  Traps 
Version
SNMP Version: SNMPv1
Select SNMPv1 or SNMPv2 using the  arrow keys, and then press
[ENT].
CONFIG: Remote  EthernetConfig  Option Card Addr
NP Card: AddrMode:Dual
BPM:Off Traffic IP
Use the  arrow keys to select AddrMode, Security, BPM, Traffic IP, or
Mgmt IP, and then press [ENT].
(E)
(E)
SNMPv2
(E)
Security: Low
Mgmt IP (E)
5–32
SLM-5650B Satellite Modem
Revision 2
MN-SLM-5650B