Table of Contents
Advertisement
Command
Arguments for
Parameter
(Instruction
Command or
Code and
Response to
Type
Qualifier)
Clear All AUPC
CAA=
None
Log Entries
Initialize AUPC
IAP=
None
Log Pointer
AUPC Local
LCL=
1 byte
Carrier Loss
Action
AUPC Local
LPC=
1 byte
Enable
Number of
N/A
3 bytes
Unread AUPC
Log Entries
Appendix C
Description of Arguments
Query
Command only.
Forces the software to clear the software AUPC log.
Note: This command takes no arguments.
Example: AAS=
Command only.
Resets internal pointer to allow RNA? queries to start at the
beginning of the stored statistics log.
Command or Query.
Tx Output Power level setting when local carrier is lost, where:
0 = Hold current output power level
1 = Goto Nominal output power level
2 = Goto Maximum output power level
Example: LCL = 0
Command or Query.
Local AUPC Control, where:
0 = Off
1 = On
Note: When Local AUPC Control is enabled, modulator output
power is automatically controlled by the modem. Power output
commands via TPL are not allowed during this mode; although,
queries will function as normal.
Example: LPC = 1 (Turn on Local AUPC Control)
Query only.
Unit returns the Number of AUPC Log Entries, which remain
Unread, in the form xxx.
Note: This means unread over the remote control.
Example: NUS = 126
Response to
Command
CAA=
CAA?
CAA*
CAA#
IAP=
IAP#
LCL=
LCL?
LCL*
LCL#
LPC=
LPC?
LPC*
LPC#
N/A
C–56
SLM-5650B Satellite Modem
Revision 2
Query
Response to
(Instruction
Query
Code and
Qualifier)
N/A
N/A
N/A
N/A
LCL?
LCL=x
(see Description of
Arguments)
LPC?
LPC=x
(see Description of
Arguments)
NUA?
NUA=xxx
(see Description of
Arguments)
MN-SLM-5650B
Advertisement
Table of Contents
