Routing | Igmp - Comtech EF Data SLM-5650B Installation And Operation Manual

Item
Priority
Hello Interval
Dead Interval
Authentication Key
Message Digest Key
8.6.5.6.3

Routing | IGMP

Use the 'Routing | IGMP' page (Figure 8-32) to facilitate use of Internet Group Management
Protocol (IGMP) with configured multicast routes.
IGMP, when enabled, responds to IGMP queries for the configured multicast routes on the transmit
side and generates IGMP queries on the receive side. If there are no active IGMP receivers on the
LAN, it will stop forwarding the multicast traffic (received from the satellite) to the LAN.
Network Processor (NP) Interface
Set priority to help determine the OSPF.
Valid range is 0 (default, or not designated) to 255.
Specify the length of time, in seconds, between the hello packets that are sent on an
OSPF interface.
Valid range is from 1 to 65535 seconds.
Set the number of seconds that a device's 'Hello' packets must not have been seen
before its neighbors declare the OSPF router down.
Valid range is from 1 to 65535 seconds.
Assign a specific password to be used by neighboring OSPF routers on a network
segment that is using OSPF's simple password authentication.
Enable OSPG MD5 authentication.
Figure 8-32. Routing | IGMP Page
8–44
SLM-5650B Satellite Modem
Description / Setting
Revision 2
MN-SLM-5650B