Np Interface Module Removal And Installation; Np Interface Module Removal Procedure; Figure 8-3. Network Processor Removal And Installation - Comtech EF Data SLM-5650B Installation And Operation Manual

8.4

NP Interface Module Removal and Installation

Ensure that the unit is POWERED OFF. Serious injury or damage to the
equipment could result if the unit is powered during module removal or
installation.
Care must be taken not to damage the module's components during removal or
installation.
8.4.1

NP Interface Module Removal Procedure

Step Task
1 Turn off the power to the modem.
Disconnect the RJ-45 cable(s) from the NP Interface Module.
2
Loosen the (two) captive thumb screws securing the module to the chassis.
3
4 Remove the module by pulling it straight out until it is clear of the chassis slot.
Network Processor (NP) Interface

Figure 8-3. Network Processor Removal and Installation

8–5
SLM-5650B Satellite Modem
Revision 2
MN-SLM-5650B