Comtech EF Data SLM-5650B Installation And Operation Manual page 109

Eb/No
RateofChange
(CONFIG:) AUPC  Local Carrier Loss Action
Carrier Loss: Local:
Use thearrow keys to select Local or Remote. Press [ENT].
Local
Remote
For either option, use the  arrow keys to select HOLD, NOMINAL, or MAXIMUM.
Press [ENT] to finish.
(CONFIG:) AUPC  Remote
Remote AUPC: Enable: Off BasebandL: Off
Tx Pattern: Off BER: Loss
Use the arrow keys to select Enable, BasebandL, Tx Pattern, or BER. Press
[ENT].
Option
Enable
BasebandL
Tx Pattern
BER
Typical for all options, use the  arrow keys to select operation as On or Off. Press
[ENT] to finish.
Front Panel Operation
Option Settings
Set the target Eb/No for AUPC at 3.2 to 16.0 dB.
Set the maximum tracking rate at 0.5 to 6.0 dB per minute (in 0.5 dB
increments).
Remote: HOLD
Option Settings
Sets the action of the local modem when it loses carrier detect.
Sets the action of the local modem when the remote modem loses carrier
detect.
Settings
View or modify the status of the remote modem's AUPC Enable.
View or modify the status of the remote modem's I/O Loopback #1 setting.
View or modify the status of the remote modem's Tx pattern substitution.
Note: In order to maintain compatibility with older Comtech EF Data modems, only
2047 pattern substitution is supported.
Monitor BER of the remote modem. The remote modem must have Tx Pattern set to On
and the local modem must be transmitting a 2047 pattern.
HOLD
(E)
(E)
5–25
SLM-5650B Satellite Modem
Revision 2
MN-SLM-5650B