Table of Contents
Advertisement
2.3
Connect External Cables
Chapter 3. REAR PANEL CONNECTORS
Connect the cables to the proper locations on the rear panel.
2.4
Configuration
If there is any problem with installation or initial operation, read Appendix A.
TROUBLESHOOTING for possible solutions.
All configurations are implemented locally via the unit's loaded firmware.
Step
Task
1
Read Chapter 5. FRONT PANEL OPERATION before continuing.
2
Connect the supplied power cable.
Set the power switch to ON.
3
4
Do a check for the correct transmitter (Tx) and receiver (Rx) output signal levels and spectrums.
5
Use the front panel keypad and display, or external PC to configure the unit.
Installation
The auto-sensing AC power supply does not require any adjustments.
2–7
SLM-5650B Satellite Modem
PINOUTS
AND
Revision 2
MN-SLM-5650B
Advertisement
Table of Contents
Need help?
Do you have a question about the SLM-5650B and is the answer not in the manual?
Questions and answers