Table of Contents
Advertisement
11.2.7
Firmware [ I ]
See Chapter 4. FLASH UPGRADING for detailed information on the
procedures associated with the TRANSEC Module firmware update
process.
The Firmware (Unit Info Menu) page, opened from the Main Menu, provides information needed
to verify that the correct firmware is loaded for operation of the unit. Note the following options or
fields:
Menu Options/Fields
[Bootrom Info]
[Bulk 1 Info]
[Bulk 2 Info]
Boot From
Reboot
TRANSEC Module SSH CLI Operation
Entry
[RO]
Displays the bootrom firmware.
[RO]
Displays the firmware version loaded into the Slot 1 location.
[RO]
Displays the firmware version loaded into the Slot 2 location.
B
Selects the firmware boot source for modem operations as follows:
0 – Newest (automatically selects the most current version firmware residing
in either Slot 1 or Slot 2);
1 – Slot 1 (selects the firmware residing in the Slot 1 location;
2 – Slot 2 (selects the firmware residing in the Slot 2 location.
Note: If the 'Boot From' selection is changed, the user must reboot the
modem in order for that firmware selection to be loaded for operation.
R
Reboots the modem. When selected, the following message displays:
This action will reboot the TRANSEC module.
Are you sure? (Y/N)
Enter 'Y' or 'N'. If 'Y' is entered, the reboot process begins by closing the
SSH CLI. On the modem front panel VFD, three messages will display at
minimum (depending on the modem's installed options):
THIS MODEM WILL REBOOT
IN FIVE SECONDS!
BOOTING MODEM...
...PLEASE WAIT
INITIALIZING MODEM...
Once the modem reboots, the user must initialize a new SSH CLI session to
resume use of this interface.
11–16
SLM-5650B Satellite Modem
Description
MN-SLM-5650B
Revision 2
Advertisement
Table of Contents
