Important Notes; Legal Bases; Subject To Changes; Personnel Qualifications - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

Important Notes

2
This section includes an overall summary of the most important safety
requirements and notes that are mentioned in each individual section. To protect
your health and prevent damage to devices as well, it is imperative to read and
carefully follow the safety guidelines.
2.1

Legal Bases

2.1.1

Subject to Changes

WAGO GmbH & Co. KG reserves the right to provide for any alterations or
modifications. WAGO GmbH & Co. KG owns all rights arising from the granting of
patents or from the legal protection of utility patents. Third-party products are
always mentioned without any reference to patent rights. Thus, the existence of
such rights cannot be excluded.
2.1.2

Personnel Qualifications

All sequences implemented on WAGO I/O System 750 devices may only be
carried out by electrical specialists with sufficient knowledge in automation. The
specialists must be familiar with the current norms and guidelines for the devices
and automated environments.
All changes to the coupler or controller should always be carried out by qualified
personnel with sufficient skills in PLC programming.
2.1.3 Use of the 750 Series in Compliance with Underlying
Provisions
Fieldbus couplers, controllers and I/O modules of the modular WAGO I/O System
750 receive digital and analog signals from sensors and transmit them to
actuators or higher-level control systems. Using controllers, the signals can also
be (pre-) processed.
This product fulfills the requirements of protection type IP20 and is designed for
use in dry interior spaces. There is protection against finger injury and solid
impurities up to 12.5 mm diameter is assured; protection against water damage is
not ensured.
The product represents an open-type device. It may only be installed in
enclosures (tool-secured enclosures or operating rooms) which fulfil the listed
requirements specified in the safety instructions in chapter "Safety Advice
(Precautions)". Use without additional protective measures in environments within
which dust, corrosive fumes, gases or ionized radiation can occur is considered
improper use.
The product is intended for installation in automation systems. It does not have
its own integrated separator. A suitable separator must therefore be created on
the plant side.
Version 1.7.0, valid from FW Version 04.01.10(23)
Important Notes 15
Manual