Fieldbus - ABB ACS580 Firmware Manual



Fieldbus

Use the settings in the Fieldbus submenu to use the drive with a fieldbus:
• Modbus (RTU or TCP)
• PROFIBUS
• PROFINET
• Ethernet/IP
You can also configure all the fieldbus related settings via the parameters (parameter
groups 50 Fieldbus adapter
data out, 58 Embedded
the protocol configurations easier.
Note that only Modbus RTU is embedded and the other fieldbus modules are optional
adapters. For the optional modules, the following adapters are required to enable the
needed protocols:
• ModbusTCP: FENA-11/-21
• PROFIBUS: FBPA-01
• PROFINET FENA-11/-21
• Ethernet/IP: FENA-11/-21
The table below provides detailed information about the available setting items in the
Fieldbus menu. Note that some of the items only became active once you have
enabled fieldbus.
Menu item
Fieldbus selection
Settings, I/O and diagnostics on the control panel 49
(FBA), 51 FBA A
fieldbus), but the purpose of the Fieldbus menu is to make
Description
Select this if you want to use the drive with a
fieldbus.
settings, 52 FBA A data in, 53 FBA A
Corresponding
parameter
51.01 FBA A type
58.01 Protocol enable