Diagnostics Menu - ABB ACS580 Firmware Manual

56 Settings, I/O and diagnostics on the control panel
The table below provides detailed information about the contents of the different
submenus available in the I/O menu.
Menu item
DI1
DI2
DI3
DI4
DI5
DI6
AI1
AI2
RO1
RO2
RO3
AO1
AO2

Diagnostics menu

To go the Diagnostics menu from the Home view, select Menu - Diagnostics.
The Diagnostics menu provides you with diagnostic information, such as faults and
warnings, and helps you to resolve potential problems. Use the menu to make sure
that the drive setup is functioning correctly.
The table below provides detailed information about the contents of the different
views available in the Diagnostics menu.
Menu item
Start, stop, reference
summary
Limit status
Description
This submenu lists the functions that use DI1 as input.
This submenu lists the functions that use DI2 as input.
This submenu lists the functions that use DI3 as input.
This submenu lists the functions that use DI4 as input.
This submenu lists the functions that use DI5 as input.
This submenu lists the functions that use DI6 or FI as input. The
connector can be used as either digital input or frequency input.
This submenu lists the functions that use AI1 as input.
This submenu lists the functions that use AI2 as input.
This submenu lists what information goes into relay output 1.
This submenu lists what information goes into relay output 2.
This submenu lists what information goes into relay output 3.
This submenu lists what information goes into AO1.
This submenu lists what information goes into AO2.
Description
This view shows where the drive is currently taking its start and stop
commands and reference. The view is updated in real time.
If the drive is not starting or stopping as expected, or runs at an undesired
speed, use this view to find out where the control comes from.
This view describes any limits currently affecting operation.
If the drive is running at undesired speed, use this view to find out if any
limitations are active.