ABB ACS580 Firmware Manual page 268

264 Parameters
No. Name/Value
AI1 percent
AI2 percent
Control panel (ref
saved)
Control panel (ref
copied)
FB A ref1
FB A ref2
EFB ref1
EFB ref2
Setpoint data
storage
Other
40.17 Set 1 setpoint 2
source
40.18 Set 1 setpoint
function
In1
In1+In2
In1-In2
In1*In2
In1/In2
MIN(In1,In2)
MAX(In1,In2)
AVE(In1,In2)
sqrt(In1)
Description
12.101 AI1 percent value
12.102 AI2 percent value
Panel reference (03.01 Panel
saved by the control system for the location where the control
returns is used as the reference.
Reference
Ext1 -> Ext2
Panel reference (03.01 Panel
the previous control location is used as the reference when
the control location changes if the references for the two
locations are of the same type (eg
frequency/speed/torque/PID); otherwise, the actual signal is
used as the new reference.
Reference
Ext1 -> Ext2
03.05 FB A reference 1
03.06 FB A reference 2
03.09 EFB reference 1 (see page 142).
03.10 EFB reference 2 (see page 142).
40.92 Setpoint data storage
Source selection (see Terms and abbreviations
Selects the second source of process setpoint. The second
source is used only if the setpoint function requires two
inputs.
For the selections, see parameter
source.
Selects a function between the setpoint sources selected by
parameters 40.16 Set 1 setpoint 1 source
setpoint 2 source.
Source 1.
Sum of sources 1 and 2.
Source 2 subtracted from source 1.
Source 1 multiplied by source 2.
Source 1 divided by source 2.
Smaller of the two sources.
Greater of the two sources.
Average of the two sources.
Square root of source 1.
(see page 160)
(see page 160)
reference, see page 141)
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
reference, see page 141) for
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
(see page 142).
(see page 142).
(see page 271)
on page 136). -
40.16 Set 1 setpoint 1
and 40.17 Set 1
Def/FbEq16
11
12
13
14
15
16
19
20
24
Not selected
In1
0
1
2
3
4
5
6
7
8