ABB ACS580 Firmware Manual page 229

No. Name/Value
30.14 Maximum
frequency
-500.00...500.00
Hz
30.17 Maximum current
0.00...30000.00 A
30.18 Torq lim sel
Torque limit set 1
Torque limit set 2
DI1
DI2
DI3
Description
Defines the maximum allowed frequency.
WARNING! This value must not be lower than
Minimum frequency.
WARNING! in frequency control mode only.
Maximum frequency.
Defines the maximum allowed motor current.
Maximum motor current.
Selects a source that switches between two different
predefined minimum torque limit sets.
0 = minimum torque limit defined by
torque limit defined by 30.20
1 = minimum torque limit selected by
torque limit defined by 30.22
The user can define two sets of torque limits, and switch
between the sets using a binary source such as a digital
input.
The first set of limits is defined by parameters
30.20. The second set has selector parameters for both the
minimum (30.21) and maximum (30.22) limits that allows the
use of a selectable analog source (such as an analog input).
30.21
0
AI1
AI2
PID
30.23
Other
30.19
30.22
0
AI1
AI2
PID
30.24
Other
30.20
Note: In addition to the user-defined limits, torque may be
limited for other reasons (such as power limitation). Refer to
the block diagram on page 429.
WARNING! In torque control mode (vector motor
control) only.
0 (minimum torque limit defined by
torque limit defined by 30.20
1 (minimum torque limit selected by
torque limit defined by 30.22
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
30.19 and maximum
are active
30.21 and maximum
are active
30.19
30.18
1
User-defined
0
minimum torque
limit
30.18
1
User-defined
0
maximum torque
limit
30.19 and maximum
are active).
30.21 and maximum
are active).
status, bit 0).
status, bit 1).
status, bit 2).
Parameters 225
Def/FbEq16
50.00 Hz
30.13
See par.
46.02
0.00 A
1 = 1 A
Torque limit
set 1
and
0
1
2
3
4