ABB ACS580 Firmware Manual page 36

32 Start-up, control with I/O and ID run
The panel returns to the previous view and
warning message Identification run is shown at
the top for a few seconds.
Panel LED starts blinking green to indicate an
active warning (AFF6).
The AFF6 warning view is shown when no key
has been pressed for one minute. Pressing
(How to fix) shows text informing that the ID run
will be done at the next start. You can hide the
warning view by pressing (Hide).
( )
Press the start key to start the ID run.
In general, it is recommended not to press any
control panel keys during the ID run. However,
you can stop the ID run at any time by pressing
( )
the stop key .
During the ID run the arrow is rotating at the top.
After the ID run is completed, text ID run done is
shown. The LED stops blinking.
If the ID run fails, fault FF61 ID run is shown. See
chapter Fault tracing on page 357 for more
information.