ABB ACS580 Firmware Manual page 22

18 Start-up, control with I/O and ID run
Direction test is optional, and requires rotating the
motor. Do not do this if it could cause any risk, or if
the mechanical set-up does not allow it.
To do the direction test, select Spin the motor
and press (Next).
Press the Start key
drive.
Check the direction of the motor.
If it is forward, select Yes, motor is spinning
forward and press
If the direction is not forward, select No, fix
direction and press
Forward direction
If you want to make a backup of the settings made
so far, select Backup and press
If you do not want to make a backup, select Not
now and press
on the panel to start the
(Next) to continue.
(Next) to continue.
Reverse direction
(Next).
(Next).