ABB ACS580 Firmware Manual page 33

Select ID run (shown only when the drive is in
vector control mode) and press
).
Select the type of ID run you want to do and
press (Select) (or
Warning message Identification run is shown at
the top for a few seconds.
Panel LED starts blinking green to indicate an
active warning.
Check the motor limits shown on the panel. If you
need other limits during the ID run you can enter
them here. The originals limits will be restored
after the ID run.
Press (Next).
(
Press the start key
In general, it is recommended not to press any
control panel keys during the ID run. However,
you can stop the ID run at any time by pressing
( )
the stop key .
During the ID run a progress view is shown.
After the ID run is completed, text ID run done is
shown. The LED stops blinking.
If the ID run fails, fault FF61 ID run
chapter Fault tracing on page
information.
Start-up, control with I/O and ID run 29
(Select) (or
).
)
to start the ID run.
is shown. See
357 for more