Programmable I/O Extensions; Fieldbus Control - ABB ACS580 Firmware Manual

94 Program features
Settings
Parameter group 10 Standard DI, RO


Programmable I/O extensions

Inputs and outputs can be added by using a CMOD-01 multifunction extension
module or a CHDI-01 115/230 V digital input extension module. The module is
mounted on option slot 2 of the control unit.
The table below shows the number of I/O on the control unit as well as optional
CMOD-01 and a CHDI-01 modules.
Digital
Location
Control unit
CMOD-01
CHDI-01
The I/O extension module can be activated and configured using parameter group
15.
Note: The configuration parameter group contains parameters that display the values
of the inputs on the extension module. These parameters are the only way of utilizing
the inputs on an I/O extension module as signal sources. To connect to an input,
choose the setting Other in the source selector parameter, then specify the
appropriate value parameter (and bit, for digital signals) in group 15.
Settings
Parameter group 15 I/O extension module


Fieldbus control

The drive can be connected to several different automation systems through its
fieldbus interfaces. See chapters
interface (EFB) (page 377) and
405).
Settings
Parameter groups
288), 52 FBA A data in
Embedded fieldbus
Digital
inputs outputs
(DI) (DO)
6 -
- 1
6 -
Fieldbus control through the embedded fieldbus
Fieldbus control through a fieldbus adapter
50 Fieldbus adapter (FBA)
(page 290), and
(page 291).
(page 150).
Digital Analog
I/Os inputs
(DIO) (AI)
- 2
- -
- -
(page 166).
(page 284),
53 FBA A data out
Analog Relay
outputs outputs
(AO)
2
-
-
(page
51 FBA A settings
(page 290) and 58
(RO)
3
2
2
(page