Ramps - ABB ACS580 Firmware Manual

Menu item
Constant speeds /
Constant frequencies
Jogging
Run permissions


Ramps

Use the Ramps submenu to set up acceleration and deceleration settings.
Settings, I/O and diagnostics on the control panel 45
Description
These settings are for using a constant value as
the reference. By default, this is set to On. For
more information, see
speeds/frequencies on page 97.
These settings allow you to use a digital input to
briefly run the motor using predefined speed and
acceleration/deceleration ramps. By default,
jogging is disabled and it can only be used in the
Vector control mode. For more information, see
Jogging on page 99.
Settings to prevent the drive from running or
starting when a specific digital input is low.
Constant
Corresponding
parameter
28.21 Constant
frequency function or
22.21 Constant speed
function
28.26 Constant
frequency 1
28.27 Constant
frequency 2
28.28 Constant
frequency 3
22.26 Constant speed 1
22.27 Constant speed 2
22.28 Constant speed 3
20.25 Jogging enable
22.42 Jogging 1 ref
22.43 Jogging 2 ref
23.20 Acc time jogging
23.21 Dec time jogging
20.12 Run enable 1
source
20.11 Run enable stop
mode
20.19 Enable start
command
20.22 Enable to rotate
21.05 Emergency stop
source
21.04 Emergency stop
mode
23.23 Emergency stop
time