How To Start Up The Drive; How To Start Up The Drive Using The First Start Assistant On The Assistant Control Panel - ABB ACS580 Firmware Manual

14 Start-up, control with I/O and ID run

How to start up the drive


How to start up the drive using the First start assistant on the
assistant control panel
Do not start-up the drive unless you are a qualified electrician.
Read and obey the instructions in chapter Safety instructions at the beginning of the
Hardware manual of the drive. Ignoring the instructions can cause physical injury or death, or
damage to the equipment
Check the installation. See chapter Installation checklist in the Hardware manual of the
drive.
Make sure there is no active start on (DI1 in factory settings, that is, ABB standard
macro). The drive will start up automatically at power-up if the external run
command is on and the drive is in the remote control mode.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if
• there is a risk of damage in case of an incorrect direction of rotation, or
• a Normal ID run is required during the drive start-up, when the load torque is higher
than 20% or the machinery is not able to withstand the nominal torque transient during
the ID run.
The two commands at the bottom of the display
(Options and Menu in the figure on the right),
show the functions of the two softkeys
located below the display. The commands
assigned to the softkeys vary depending on the
context.
Use keys , ,
and/or change values depending on the active
view.
?
Key shows a context-sensitive help page.
For more information, see ACS-AP-x assistant
control panels user's manual (3AUA0000085685
[English]).
Language, date and time, and motor nominal values
Have the motor name plate data at hand.
Power up the drive.
Safety
Hints on using the assistant control panel
and to move the cursor
1 – First start assistant guided settings:
and