ABB ACS580 Firmware Manual page 25

Start-up, control with I/O and ID run 21
2 – Additional settings: Start, stop and reference values
If you do not wish to use a macro, define the
settings for start, stop and reference:
Select Start, stop, reference and press
(Select) (or ).
Adjust the parameters according to your needs.
Select parameter and press (Select).
When you change the settings, you also change
the use of the I/O signals in the drive. Make sure
the actual I/O wiring and the use of I/O in the
control program match each other. You can check
the current I/O use in the I/O menu under the
Main menu (see page 22).
After making the adjustments, go back to the
Primary settings menu by pressing
(Back).
2 – Additional settings: Ramps
(acceleration and deceleration times for the motor)
Select Ramps and press (Select) (or ).
Adjust the parameters according to your needs.
Select a parameter and press (Edit).
After making the adjustments, go back to the
Primary settings menu by pressing
(Back).