ABB ACS580 Firmware Manual page 65

Terminal sizes:
R0...R3: 0.2...2.5 mm
0.14...1.5 mm
R5...R9: 0.14...2.5 mm
Tightening torques: 0.5...0.6 N·m (0.4 lbf·ft)
Notes:
1)
See Menu - Primary settings - Start, stop, reference - Constant frequencies or parameter
group 28 Frequency reference
DI3 DI4
0 0
1 0
0 1
1 1
2)
See Menu - Primary settings - Ramps or parameter group
DI5 Ramp set
0 1
1 2
3)
Ground the outer shield of the cable 360 degrees under the grounding clamp on the
grounding shelf for the control cables.
4)
Connected with jumpers at the factory.
5)
Note: Use shielded twisted-pair cables for digital signals.
Input signals
•
Analog frequency reference (AI1)
•
Start/stop selection (DI1)
•
Direction selection (DI2)
•
Constant frequency selection (DI3, DI4)
•
Ramp set (1 of 2) selection (DI5)
Output signals
•
Analog output AO1: Output frequency
•
Analog output AO2: Motor current
•
Relay output 1: Ready run
•
Relay output 2: Running
•
Relay output 3: Fault (-1)
2
(terminals +24V, DGND, DCOM, B+, A-)
2
(terminals DI, AI, AO, AGND, RO, STO)
2
(all terminals)
chain.
Operation/Parameter
Set frequency through AI1
28.26 Constant frequency 1
28.27 Constant frequency 2
28.28 Constant frequency 3
Parameters
28.72 Freq acceleration time 1
28.73 Freq deceleration time 1
28.74 Freq acceleration time 2
28.75 Freq deceleration time 2
Control macros 61
28 Frequency reference chain.