Timed Functions - ABB ACS580 Firmware Manual

240 Parameters
No. Name/Value
32.56 Supervision 6
action
No action
Warning
Fault
32.57 Supervision 6
signal
32.58 Supervision 6 filter
time
0.000 ... 30.000 s
32.59 Supervision 6 low
-21474836.00...
21474836.00
32.60 Supervision 6 high
-21474836.00...
21474836.00
32.61 Supervision 6
hysteresis
0.00...100000.00
34

34 Timed functions

34.01 Combined timer
status
Bit Name
0 Combined timer 1
1 Combined timer 2
2 Combined timer 3
3...15 Reserved
0000h...0FFFFh
34.02 Timer status
Description
Selects whether the drive generates a fault, warning or
neither when the value monitored by signal supervision 6
exceeds its limits.
Note: This parameter does not affect the status indicated by
32.01 Supervision status.
No warning or fault generated.
Warning A8B5 Signal supervision
Drive trips on fault 80B5 Signal
Selects the signal to be monitored by signal supervision
function 6.
For the available selections, see parameter
Supervision 1 signal.
Defines a filter time constant for the signal monitored by
signal supervision 6.
Signal filter time.
Defines the lower limit for signal supervision 6.
Low limit.
Defines the upper limit for signal supervision 6.
Upper limit.
Defines the hysteresis for the signal monitored by signal
supervision 6.
Hysteresis.
Configuration of the timed functions.
See also section Timed functions
Status of the combined timers. The status of a combined
timer is the logical OR of all timers connected to it.
This parameter is read-only.
Description
1 = Active.
1 = Active.
1 = Active.
Status of combined timers 1...3.
Status of timers 1...12.
This parameter is read-only.
is generated.
supervision.
32.07
(page 118).
Def/FbEq16
No action
0
1
2
Zero
0.000 s
1000 = 1 s
0.00
-
0.00
-
0.00
-
-
1 = 1
-