ABB ACS580 Firmware Manual page 142

138 Parameters
Group
46 Monitoring/scaling settings
47 Data storage
49 Panel port communication
50 Fieldbus adapter (FBA)
51 FBA A settings
52 FBA A data in
53 FBA A data out
58 Embedded fieldbus
71 External PID1
76 PFC configuration
77 PFC maintenance and
monitoring
95 HW configuration
96 System
97 Motor control
98 User motor parameters
99 Motor data
Contents
Speed supervision settings; actual signal filtering; general scaling
settings.
Data storage parameters that can be written to and read from
using other parameters' source and target settings.
Communication settings for the control panel port on the drive.
Fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
Configuration of the embedded fieldbus (EFB) interface.
Configuration of external PID.
PFC (Pump and fan control) and Autochange configuration
parameters. See also section Pump and fan control (PFC) on
page 114.
PFC (Pump and fan control) and Autochange configuration
parameters. See also section Pump and fan control (PFC) on
page 114.
Various hardware-related settings.
Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection.
Switching frequency; slip gain; voltage reserve; flux braking; anti-
cogging (signal injection); IR compensation.
Motor values supplied by the user that are used in the motor
model.
Motor configuration settings.
Page
279
282
283
284
288
290
290
291
297
299
305
305
307
312
315
316