ABB ACS580 Firmware Manual page 179

No. Name/Value
In1 Start
In1 Start; In2 Dir
In1 Start fwd; In2
Start rev
In1P Start; In2 Stop
Description
The source of the start and stop commands is selected by
parameter 20.03 Ext1 in1
source bits are interpreted as follows:
State of source 1 (20.03)
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
0
The source selected by
signal; the source selected by
determines the direction. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
The source selected by
start signal; the source selected by
the reverse start signal. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
0
1
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1
(20.03)
0 - > 1
Any
Notes:
• Parameter 20.02 Ext1 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
source. The state transitions of the
Command
Start
Stop
20.03 Ext1 in1 source is the start
20.04 Ext1 in2 source
State of source 2
(20.04)
Any
0
1
20.03 Ext1 in1 source is the forward
20.04 Ext1 in2 source
State of source 2
(20.04)
0
0
0 -> 1 (20.02 = Edge)
1 (20.02 = Level)
1
and 20.04 Ext1 in2
State of source 2
(20.04)
1
0
has no effect with
Parameters 175
Def/FbEq16
1
2
Command
Stop
Start forward
Start reverse
3
is
Command
Stop
Start forward
Start reverse
Stop
4
source.
Command
Start
Stop