Issue 1.2
5 - 44
Figure 5-31 Installing the Handset (DT400)
4.1.2
Connecting the Line Cord
Confirm the location of the line connector on the bottom of the
multiline terminal. Then, connect the line cord to the multiline terminal
using the steps shown below.
4.1.2.1
Line Cord Connection DT300
1.
Figure 5-32 Installing the Line Cord (DT300)
2.
Install the modular plug of the Line Cord into the Line
Connector at the back of terminal. Push until it snaps into
place. Refer to
Figure 5-32 Installing the Line Cord
Install the Line Cord in the groove. Refer to
Installing DT Series Digital and IP Multiline Terminals
UNIVERGE SV9100
(DT300).
Figure 5-33 Line