Table of Contents
Advertisement
Lubrication system: oil cooler
Locate the cooler (1) on the front subframe pins and secure it with the screw (4) tightened to a torque of 10 Nm ±10%
(Sect. 3 - 3,
Frame torque
settings).
Set the gaskets (8) in the nipples (7) and grease the pipe (5) and (6) O-rings with engine oil.
Attach the unions (D) of hoses (5) and (6) to the nipples (7), finger-tightening the union nuts.
Tighten the unions (D) to a torque of 25 Nm ±5% (Sect.
3 - 3,
Frame torque
settings).
Lay hoses into retainers (B) of cover (C) and fasten retainers. Position the hoses into cable grommet (10) and tighten the
screw (9) to a torque of 10 Nm ±10% (Sect. 3 - 3,
Frame torque
settings).
Advertisement
Chapters
Table of Contents
