Ducati Monster 796 Workshop Manual page 244

System components
Temperature sensor
This sensor is powered by the ECU and provides information regarding the temperature of the aspirated air.
The electronic signals thus obtained are transmitted to the ECU, where they are used to make corrections in accordance
with the temperature reading.
Note
To test the operation of the injector, use the DDS diagnosis instrument and follow the instructions given in the paragraph
"Guided diagnosis" (Sect. 6 - 13).
Removing the air temperature sensor
To disassemble the air temperature pressure sensor (1).
Operations
Remove the seat
Remove the tank covers
Remove the fuel tank
Remove the ABS control unit
Remove the battery
Remove the ECU connector
Connect the starter motor/solenoid
cable
Remove the airbox
Disconnect the main wiring connector (1) from the sensor, unscrew and remove the two sensor retaining screws (2) and
remove the sensor from the vertical cylinder intake manifold (3).
Section reference
5 - 3, Removal of the seat
5 - 2, Removal of the fuel tank
fairings
8 - 2, Removal of the fuel tank
7 - 6, Removing of the ABS control
unit
6 - 2, Battery support
6 - 12, Removal of the electronic
control unit
6 - 3, Removal of the starter motor
8 - 7, Removal of the airbox