Ducati Monster 796 Workshop Manual page 469

Throttle body
Warning
The hose (16) which mounts the air temperature sensor (17) should be installed on the same side of the throttle body as
the position sensor (2).
Note
The end of the hose with the smaller diameter is to be connected to the throttle body.
Take couplings fully home on throttle body, ensuring the mould parting lines (M) of couplings match with the right-hand
edge of throttle body sockets (H), as shown below.
Tighten the clamps to a torque of 1.5 Nm ±10% (Sect. 3 - 3,
shown in the figure and ensuring they do not pop out of their seats (L) on couplings.
Frame torque settings), complying with the positioning