Draining The Brake Circuit - Ducati Monster 796 Workshop Manual

Maintenance operations
Loosen the bleed valve (8) to allow fluid to escape.
The pedal is at the end of the stroke in lower position.
Now tighten the bleed valve (8) to a torque of 10 Nm±10% (Sect. 3 - 3,
press the pedal.
Repeat the operation described above until the old liquid flows completely.
Warning
After eliminating the old fluid from the tank, during the refilling operation always keep the oil level above the MIN mark to
prevent the formation of air bubbles inside the circuit.

Draining the brake circuit

Warning
Brake fluid is corrosive and will damage paintwork. Avoid contact with eyes and skin. In the case of accidental contact,
wash the affected area thoroughly with plenty of running water.
Remove the cover (1) and membrane from the front brake fluid reservoir (2) by loosening screws (3) and the cover (6)
from the rear brake fluid reservoir (7).
Frame torque settings) and release the pedal;