Table of Contents
Advertisement
Gearbox assembly: gearchange mechanism
Reassembly of the gear selector lever
If the components of the gearchange mechanism were dismantled on removal, fit the spring (17) on the shaft (16) in the
position indicated in the photo. Grease the threaded end of the eccentric gearchange lever pin (15) and install it on the
upper part of the gearchange lever, securing it with the nut (13). Screw the nut on by hand (do not tighten)).
Insert the shaft (16) in stop plate (23) and washer (24) and secure with circlip (9).
Advertisement
Chapters
Table of Contents
