Refitting The Aptc Clutch - Ducati Monster 796 Workshop Manual

Hide thumbs Also See for Monster 796:

Table of Contents

Clutch assembly: APTC wet clutch

Refitting the APTC clutch

Locate the spacer (11) on the drum (A).

Position the hub-plates-drum assembly (B) inside the drum (A).

Place the last clutch plate (M) offset with respect to the others.

Locate the lock washer (9) on the primary shaft, seating it against the clutch assembly.

Apply the recommended grease to the contact face of the nut (8) and to thread of the primary shaft, then fit the nut to

the input shaft and tighten by hand.

Restrain the clutch drum with tool part no. 88713.2556 when tightening nut (8).

Tighten the nut (8) to a torque of 190 Nm (Min. 180 Nm - Max. 200 Nm) (Sect. 3 - 3,

Engine torque

Remove service tool no. 88713.2556.

Table of Contents