Table of Contents
Advertisement
Flywheel - alternator
Install under the screw (12), in correspondence with the starter motor, the spacer (8), the cable guide (9), the washer
(38) and install the cover (1) under screw (11) in correspondence with the alternator lead: for instructions on the
positioning of the wiring under the cover (1) see below.
Tighten the retaining screws to a torque of 13.5 Nm (Min. 12.5 Nm - Max. 14.5 Nm) (Sect. 3 - 3,
Engine torque
settings).
Check that the fuel tank drain hose (T) and the airbox drain hose (U) are positioned in the lower slot of the cover (1) as
shown.
Advertisement
Chapters
Table of Contents
