Table of Contents
Advertisement
Lights and indicating devices
If removed, reposition the turn indicators to headlight mount, with the drain slot (F) facing down; position the stop plate
(5) as shown.
Apply the recommended threadlocker to the screws (6). Start the screws (6) in their thread ensuring that the slot on stop
plate (5) perfectly matches the tabs on turn indicators. Tighten the screws (6) to a tightening torque of 3 Nm ±10%
(Sect. 3 - 3,
Frame torque
settings).
Note
For the US version you shall install spacer (T) between turn signal and headlight support. Position spacer with slot facing
down. Route the turn signal wiring through the slot on spacer bottom, ensuring not to leave it too taut or the fast-on
connectors inside the turn indicators might detach.
Position the headlight to the headlight support and set it as shown, ensuring that the turn indicator wiring is not squashed
under the headlight.
Fit the spacers (7) and the screws (3). Tighten the screws (3) to a torque of 5 Nm ±10% (Sect. 3 - 3,
Frame torque
settings).
Position the headlight cover (8), setting it as shown onto headlight support (9).
Advertisement
Chapters
Table of Contents
