Table of Contents
Advertisement
Exhaust system
Refit the cable (36) on the exhaust valve motor (37) inserting the end fitting (D) in the pulley hole.
Fix the cable (36) with the clip (46).
Refit the cable (36) inserting the end fitting (A) on the exhaust valve (B) and secure it with the circlip (45).
Adjust cable (36) on exhaust valve and exhaust valve motor as explained under Sect. 4 - 3,
Adjusting the exhaust valve
bowden
cable.
Set the exhaust valve motor (37) onto rear number plate holder, paying attention to position the spring (F) as shown.
±
Insert the fixing screws (15) with washers (38). Tighten the screws (15) to a torque of 10 Nm
10% (Sect. 3 - 3,
Frame
torque
settings).
Advertisement
Chapters
Table of Contents
