Final drive
Fully unscrew the nut (8) and remove the washer (9) and the flange (11) with the sprocket (7).
Recover the spacer with collar (15).
Using a mallet, tap the sprocket flange (11) with the cush drive bushes (12) off the sprocket (7).
Refitting the rear sprocket
Check the cush drive bushes (12) for signs of wear and, if necessary, remove from the sprocket flange and renew them.
Refitting is the reverse of removal.
If it is necessary to remove the cush drive bushes (12), grease all the coupling surfaces and the undersides of the fixing
nuts (10) of the cush drive bushes (12) with the recommended grease.
Check for wear following the instructions given at the beginning of this section.