Removal Of The Seat Release Mechanism - Ducati Monster 796 Workshop Manual

Tail light-number plate holder and locks
Refit the tail light - number plate holder assembly to the rear subframe, inserting it as shown in the photo.
Fit and tighten the four screws (25) to a tightening torque of 22 Nm ±10% (Sect. 3 - 3,
Connect the main wiring connector (A) to the main wiring harness (Sect. 6 - 1, Routing of wiring on frame).
Operations
Refit the exhaust valve motor
Refit the tool tray
Refit the seat

Removal of the seat release mechanism

Remove the tail light - number plate holder assembly from the rear subframe and the plate (24) as described in the
Section reference
8 - 8, Refitting the exhaust system
5 - 3, Refitting the tool tray
5 - 3, Refitting the seat
Frame torque settings).