Exhaust system
Fasten wiring (C) to exhaust valve motor central body using the rubber clamp (39) and ensuring that the cables coming
out of motor do not touch the metal sheet sharp edge.
Connect the exhaust valve motor wiring (C) and fasten it with the clamp (40).
Refit the protection (35), starting the screw (42) with washers (34) and the spacer (25).
Note
When installing the protection (35), ensure that slot (G) matches the tab (H), as shown below.
Fasten the central exhaust pipe (5) to the mounting bracket of tank and exhaust (E) tightening the nuts (20) to a torque
±
of 22 Nm
10% (Sect. 3 - 3,
Frame torque
settings).