Ducati Monster 796 Workshop Manual page 396

Rear swingarm
Evenly apply the recommended grease to the thread (M) of the pin (27).
Fit the rear wheel shaft (27) to hub fully home.
Fit the inner bush (18) on wheel shaft (27), and position it so as the taper end is facing the shaft, as shown, then tighten
the screws (3) to a torque of 31 Nm ±5% (Sect. 3 - 3, Frame torque settings) according to a 1-2-1 sequence.
Route the speed sensor cable inside the two hose clips (25).
Smear the thread of the two screws (24) with recommended threadlocker and fit two washers (N) in-between.
Fasten hose clips (25) to swing arm, setting them as illustrated in the figure and then tighten the screws (24) to a torque
of 1 Nm ±10% (Sect. 3 - 3, Frame torque settings).