Ducati Monster 796 Workshop Manual page 85

Maintenance operations
Turn the clip indicated by the arrow to the position shown in the figure.
Route cable in the tunnel provided between plate and number plate holder.
Position and fasten the valve motor to the rear subframe plate by means of two screws (7) and two washers (8).
±
Tighten the screws (7) to a torque of 10 Nm 10% (Sect. 3 - 3, Frame torque settings).
Fasten the electric cable to the motor central body using a rubber clamp L82.
Ensure the cable is not touching the metal plate edge (area indicated by the arrow).
Turn exhaust valve pulley clockwise fully and hold it in this position.
Slide off the dust gaiter (12) from the sheath end.
Fit sheath end into the left-hand hole available on the plate above the valve pulley and refit the dust gaiter.
Fit cable end into the pulley hole indicated in the figure and release pulley so as cable is taut again.