Table of Contents
Advertisement
Indicating devices
Checking the right-hand handlebar switch
To remove the right-hand handlebar switch, undo the retaining screws (1) and disconnect the wiring connector from the
electric system.
The colours mentioned in the following descriptions refer to the colours of the wires from the switch and not to the colours
of the wires of the main electric system.
Engine Stop button
Using a multimeter, check for electrical continuity between the RED/WHITE AND RED/BLACK cables (see Sect. 6 - 13,
Using a multimeter to check the electrical
systems, for information on the operation of the multimeter). When the switch
is in the RUN position, there should be electrical continuity between the two wires. When the switch is in the OFF position
there should be no electrical continuity between the two wires.
If these conditions are not met, the ENGINE STOP switch is not working correctly and must be renewed.
STARTER button
Proceed as described for the engine stop button and check for electrical continuity between the BLUE/WHITE AND BLACK
cables when the STARTER button is pressed (see Sect. 6 - 13,
Using a multimeter to check the electrical systems
concerning operation of the multimeter). If there is no continuity, the STARTER switch is defective and must be renewed.
Refit the right-hand switch, tightening the screws (1) to a torque of 2.5 Nm ±10 (Sect. 3 - 3,
Frame torque
settings).
Advertisement
Chapters
Table of Contents
